This is a working overview of research peptide, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-05-31. Anything still debated is marked as such rather than presented as settled.
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
TB-500 is a laboratory label applied to a short synthetic peptide that is widely described as a fragment of thymosin beta-4, an actin-binding protein present in most mammalian cells. Suppliers and review articles usually present TB-500 as the N-terminal region of that protein, but the exact sequence attached to the name is not consistent across sources. Some product descriptions list a seven-residue chain; others use the label loosely for the parent protein itself. Because of that variation, any technical discussion of TB-500 needs to state which sequence is meant.
Proposed activity centers on actin sequestration and on the movement of cells during repair processes. In cell culture and animal models, the fragment has been associated with migration, tube formation, and tissue remodeling. These observations are frequently described as preliminary, because most published work uses rodent or in vitro systems rather than controlled human trials. Whether the short fragment reproduces the effects of the full protein remains an open question, and the relationship between dose, route, and measured outcome is not well characterized.
The compound circulates in the literature as a research reagent rather than an approved therapeutic. Regulatory agencies in several countries have not authorized it for medical use, and sporting bodies list related thymosin beta-4 peptides among prohibited substances. Suppliers typically market it with a purity figure and a certificate of analysis, while peer-reviewed clinical reports remain sparse. Discussions therefore often separate laboratory findings from anecdotal reports, and reviewers tend to note the small size and methodological limits of the available studies.
| Property | Value | Notes |
|---|---|---|
| Physical form | Lyophilised powder | Sealed vial; reconstituted before laboratory use |
| Appearance | White to off-white solid | Visual descriptor used on certificates of analysis |
| Solubility class | Water-soluble | Dissolves in water and aqueous buffers |
| Reported mass, fragment | Near 889 Da | Value depends on the stated sequence |
| Reported mass, parent protein | Near 4963 Da | 43-residue thymosin beta-4 |
TB-500 is a short synthetic peptide sold under a trade name rather than a systematic chemical name. Suppliers usually describe it as a fragment of thymosin beta-4 and ship it as a lyophilised powder intended for laboratory use. Because the label is commercial, the exact sequence attributed to it is not fully consistent across catalogues, and some listings present a seven-residue peptide while others describe related fragments of similar length. It is not an approved medicine in any major jurisdiction, and it is handled as a research chemical.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
The use of mAbs that specifically bind to carbohydrate epitopes of AGPs have also been employed to infer functions based on the location and pattern of the AGP epitopes. Commonly used mAb against AGPs include CCRC-M7, LM2, JIM8, JIM13 and JIM14. The function of individual AGPs has largely been inferred through studies of mutants. For example, the Arabidopsis root-specific AtAGP30 was shown to be required for in vitro root regeneration suggesting a function in regenerating the root by modulating phytohormone activity. Studies of agp6 and agp11 mutants in Arabidopsis have demonstrated the importance of these AGPs to prevent uncontrolled generation of the pollen grain and for normal growth of the pollen tube. The functional mechanisms of AGPs in cell signalling is not well understood. One proposed model suggests AGPs can interact and control the release of calcium from AG glycan (via GlcA residues) to trigger downstream signalling pathways mediated by calcium. Another possible mechanism, largely based on the study of FLAs, suggests the combination of fasciclin domain and AG glycans can mediate cell-cell adhesion.
A familial form of pseudohyperkalemia, a benign condition characterised by increased serum potassium in whole blood stored at cold temperatures, also exists. This is due to increased potassium permeability in red blood cells.
In June 2022, during the annual OECD Ministerial Council Meeting, the Roadmaps for the Accession to the OECD Convention for Brazil, Bulgaria, Croatia, Peru and Romania were adopted. In March 2024, the Roadmaps for the Accession to the OECD were adopted with Argentina and Indonesia, and in July 2024, also with Thailand.
=== Optimal substrates === For many of these enzymes the optimal substrate is hydrogen peroxide, but others are more active with organic hydroperoxides such as lipid peroxides. Peroxidases can contain a heme cofactor in their active sites, or alternately redox-active cysteine or selenocysteine residues. The nature of the electron donor is very dependent on the structure of the enzyme.
Sources: en.wikipedia.org
This results in generalized inflammation in the heart, producing acute erosions and vegetations with fibrin deposition in the mitral valve that may be followed by chronic changes over years to decades, including shortening of the chordae tendinae and thickening or fusion of the mitral leaflets, leading to a severely compromised "buttonhole" or "fish mouth" valve. In 70% of cases rheumatic heart disease involves only the mitral valve, while 25% of cases involve both the aortic and mitral valves. Involvement of other heart valves without damage to the mitral is exceedingly rare. Mitral stenosis is almost always caused by rheumatic heart disease. Less than 10% of aortic stenosis is caused by rheumatic heart disease. Rheumatic fever can also cause chronic mitral and aortic regurgitation. While developed countries once had a significant burden of rheumatic fever and rheumatic heart disease, medical advances and improved social conditions have dramatically reduced their incidence. Many developing countries, as well as indigenous populations within developed countries, still carry a significant burden of rheumatic fever and rheumatic heart disease and there has been a resurgence in efforts to eradicate the diseases in these populations. Among persons who have experienced rheumatic fever, long-term intramuscular antibiotic therapy is used as secondary prophylaxis against additional streptococcal infections, which can contribute to progression of rheumatic heart disease.
== See also == Protein serine/threonine phosphatase, enzyme for reverse process. Pseudokinase, a protein without enzyme activity (pseudoenzyme). It can be related to proteins of this class. ATM serine/threonine kinase, responsible for the disorder ataxia–telangiectasia.
==== Effect of size, shape, composition and environment ==== As a general rule, the wavelength of light absorbed increases as a function of increasing nanoparticle size. Both the surface plasmon resonance frequency and scattering intensity depend on the size, shape composition and environment of the nanoparticles. This phenomenon may be quantified by use of the Mie scattering theory for spherical nanoparticles. Nanoparticles with diameters of 30–100 nm may be detected easily by a microscope, and particles with a size of 40 nm may even be detected by the naked eye when the concentration of the particles is 10−4 M or greater. The scattering from a 60 nm nanoparticle is about 105 times stronger than the emission from a fluorescein molecule.
Sources: en.wikipedia.org
No. TB-500 is a trade-style label used for a synthetic peptide described as a fragment of thymosin beta-4, while thymosin beta-4 is the full 43-residue protein. The two differ in size and are not interchangeable terms in analytical work.
Naming for research peptides is not standardised, and suppliers sometimes apply the same label to different chain lengths. Certificates of analysis and mass data are the practical way to determine what a given lot contains.
The fragment commonly cited under this label is reported near 889 Da, and the parent protein near 4963 Da. Reported values shift with the exact sequence and with residual counter-ions or water in the sample.
TB-500 is a name used for a short synthetic peptide fragment taken from the actin-binding region of thymosin beta-4. Material sold under this label is usually a lyophilized powder supplied for laboratory research rather than a licensed medicine. The commonly cited sequence is LKKTETQ.